USB is getting a facelift!
In the beginning, there was USB 1.1, with the "low speed" and "full speed" devices (at 1 Mbps and 12 Mbps, respectively). Then USB 2.0 came along with "high speed" devices that ran at 480 Mbps. Now the new USB 3.0 bus specification defines "SuperSpeed" devices that run at 5 Gbps (5,120 Mbps).
Now that the bus specification is public, I can finally talk about the code I've been developing at work. I've been writing a Linux driver for xHCI (the new USB 3.0 host controller), and changing the Linux kernel stack to support USB 3.0 devices. On November 17th, I got to demo my work at the world's first USB 3.0 "SuperSpeed" Developers Conference.
This is a demo showing a USB 3.0 Mass Storage Device (commonly called a USB drive, thumb drive, or flash drive) prototype running under Linux with an unmodified Mass Storage Device driver. My Linux xHCI driver is necessary to communicate with the USB 3.0 device through the xHCI host controller prototype. The FPGA prototype was provided by Fresco Logic, a company that sells host controller and device IP.
The demo showed speeds that were about 3.5 times faster than USB 2.0 high speed devices. I expect this demo to be even faster when the device and host controller are implemented in silicon.
Details about USB 3.0
USB 3.0 is 10 times faster than USB 2.0. Roughly speaking, it means that a file that takes 30 minutes to transfer over USB 2.0 could take 3 minutes to transfer under USB 3.0.
USB 3.0 also provides better power management, which translates to longer laptop battery life. USB 3.0 is backwards compatible. That means you can plug all your USB 2.0 devices into a USB 3.0 port, or plug your USB 3.0 device into a USB 2.0 port. The USB 3.0 device will work at USB 2.0 speeds in the latter case, but that means consumers don't have to upgrade their PC or laptop to use USB 3.0 devices at the slower speed.
| link | 40 comment(s)
I now have reCaptcha comment verification working on this blog, which means comments are re-enabled. This is my first time dabbling with python, so the results are not polished. :) Details and patches below.
| link | 5 comment(s)
